IBOK GP100 PDF

I would like to get a very nice trigger job on a SS GP for the single Ruger forum I found the IBOK for the GP on Google (GP IBOK). I received the GP pdf this morning. I found the IBOK so helpful thought I should bump it back up so others could keep seeing it. There is a great resource called the GP IBOK that is a must have the original author had to remove it due to copywrite claims but you can.

Author: Domuro Zutilar
Country: Reunion
Language: English (Spanish)
Genre: Life
Published (Last): 24 July 2008
Pages: 240
PDF File Size: 3.85 Mb
ePub File Size: 17.36 Mb
ISBN: 830-2-66481-758-7
Downloads: 22364
Price: Free* [*Free Regsitration Required]
Uploader: Nikolar

You may have to help it a little by wiggling the cylinder. I was impressed with the way she handled the error. Once seated, swing the cylinder into the latched position. Trigger begins to move to the rear.

Turn the gun sideways with the serial number side up. Place your thumb and fingers between the bottom of the ejector star wheel and the top of the cylinder to hold the ejector up. I’ve been shooting 9mm and. GPs are made in two basic configurations.

Use a gap gauge blade to push it into position. Much like the trigger, you will usually see about.

  LIBRO APRENDIZ BRUJO PNL PDF

Leave a Reply Cancel reply Enter your comment here Besides the springs, the only non-stainless parts are the grips and sights. Again, Iowegan, thank you for the insightful reference.

Send a private message to Apocalypse Now.

MODERATORS

The complete assembly will pop out. I like ibkk 5er, I think that’s the magic size between the 4. Excellent post, thanks man! On adjustable sight models, the front sight can be easily removed and replaced with a different type sight. Ruger typically installs a stronger mainspring than is necessary. Super Redhawk front sights are interchangeable with the GP and have a red insert.

Send a private message to Big Andy A long crane latch pin will prevent the front latch from securing the front of the cylinder assembly.

It too must be very smooth. Find all posts by Hungry. This entry was posted on August 24, at 5: Pull the trigger and ease the hammer down. If it is too short, a new one will have to be fitted and installed at the Ruger factory.

Mon Dec 03, Hold the crane so the flat surface is up. The blued models are investment cast from high strength steel and are finished with a hot blue process.

New GP – Survivalist Forum

As Gunner mentioned, Iowegan is a master gunsmith and a true gentleman. After the parts have been cleaned, insert the ejector from the rear and the gp10 and center pin rod from the front. You may also want some speedloaders, I like Safariland Comp IIs, cheap, medium size and easy to use once you get a feel for them.

  KATALOG WARDAH 2013 PDF

SA sear releases the hammer. It should spin freely with no binds.

Ruger GP Book of Knowledge « Gunner’s Journal

To remove the rear sight blade, turn the windage screw counter-clockwise until the right edge of the sight blade is gp1000 with the sight base. To install endshake bearings, put a drop of oil on the end of the crane tube and another drop on the front tube flange.

Cylinder latch engages the cylinder notch. If you examine the firing pin protrusion with the trigger pulled and the hammer pushing the transfer bar forward, you will get a false indication of protrusion.